Unpacking - Mitsubishi Electric CP-D70DW Operation Manual

UNPACKING

Take the printer out of the box by the following procedures. Make sure to check the accessories.
O p e n t h e t o p o f t h e b o x a n d r e m o v e t h e
accessories together with the cushion.
Remove the protective cardboard and then take the accessories
out of the cushion.
Pull the printer up carefully to take it out of the
box.
Pull the printer straight up as shown in the figure.
This printer is about 12 kg (CP-D70DW) or about 22 kg (CP-
D707DW) in weight. Handle them with care.
When pulling out or transporting CP-D707DW, make sure to do
with two persons.
Unwrap the packing.
When moving this printer, remove the paper strip bin and then
hold the upper front part and the handle on the rear side.
Remove the protective materials for transportation such as
protective sheet.
Do not transport the printer by holding the part under the paper
strip bin. The paper strip bin may be removed and fall. It may
cause injury or damage.
CONTENTS
The accessories are contained in the upper cushions. Check the contents.
Quick setup
CD-ROM
guide
UNPACKING
NOTE
CAUTION
Power cords Banding bands
Paper flanges Spacers
Ink cassette Paper strip bin
These are contained in the printer.
CP-D70DW
Securing band
Screws
Make sure to remove
the protective materials
from the ink cassette
and paper flanges.
CP-D707DW
6