Table of Contents
Advertisement
Intellisense battery
Battery installation
To install the battery:
1.
With the label on the
battery facing the AED
battery compartment,
insert the battery as shown
in the drawing.
2.
Push the latched end of the
battery firmly into the
AED, as shown in the
drawing, until the battery
snaps into place. The
exposed side of the battery
should be flush with the
outside of the AED case.
3.
Wait a few seconds and
then open the lid for 5
seconds to initiate a self-
test.
If the battery is installed
properly:
•
•
If service is required, the Service indicator illuminates instead.
Contact Cardiac Science Technical Support (see
information
Science representative.
Powerheart® AED G3 Plus 9390A and 9390E
The Smartgauge
battery indicator LEDs
illuminate
The Rescue Ready
status indicator turns green.
on page 1-2) or outside the U.S., your local Cardiac
0%
100%
Contact
70-00915-01 F
2-7
Advertisement
Table of Contents
