SolidRF Building Force Pro5 MANT User Manual page 10

This booster including safeguards to protect the cellular network from interference. Each Signal Booster is individually tested
and factory set to ensure FCC compliance.
1. The Signal Booster cannot be adjusted without factory reprogramming or disabling the hardware.
2. The Signal Booster will amplify, but ONLY incoming and outgoing signals in order to increase coverage of authorized
frequency bands.
3. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected.
4. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will
automatically turn the power off on that band.
5. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 minute.
After 5 times consecutive such automatic restarts, if the detected oscillation still remains, any problematic bands are
permanently shut off until the Signal Booster has been manually restarted by reconnecting power supply to the Signal
Booster.
6. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
This is a CONSUMER device
BEFURE USE ,you MUST REGISTER THIS DEVICE with your wireless provider and have your
provider's consent .Most wireless provider consent to the use of signal boosters .Some
provider may not consent to the use of this device on their network .If you are unsure,
contact your provider.
You MUST operate this device with approved antenna and cables as specified by the
manufacturer .Antennas MUST be installed at least 20cm (8inches) from any person.
You MUST cease operating this device immediately if requested by the FCC or a licensed
wireless service provider.
WARNING.E911 location information may not be provided or may be inaccurate for calls
served by using this device.
This device may be operated ONLY in a fixed location for in-building use.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help
Contact information for providers
A subscriber must have the consent of a wireless provider to operate a consumer signal booster. Please register your
booster with your wireless service provider, refer to contact information for providers:
Sprint:
signalbooster@sprint.com
T-Mobile:
www.T-Mobile.com/BoosterRegistration
https://support.t-mobile.com/docs/DOC-9827
Verizon:
http://www.verizonwireless.com/wcms/consumer/register-signal-booster.html
AT&T:
https://securec45.securewebsession.com/attsignalbooster.com/
U.S. Cellular:
http://www.uscellular.com/uscellular/support/fcc-booster-registration.jsp
Metro PCS
https://www.metropcs.com/support/signal-booster
Description of network protection features:
www.SolidRFCanada.com 10