Table of Contents
Advertisement
Ensuring the door seals correctly:
It is normal for the seal to be compressed after the door has been
reversed. With the door closed, use a hair dryer to expand the seal
and fill the gap between the door and the body of the appliance.
Take care not to use the hair dryer too close to the appliance, which
could damage the seal. A distance of approximately 10cm should be
adequate.
When completed, allow the seal and door to cool before touching them.
Once done, the seal should remain in position.
Electrical information
Warning! This appliance must be earthed.
B
Fig. 15
The mains lead of this appliance has been fitted with a BS 1363A
13Amp fused plug. To change a fuse in this type of plug, follow the
steps below:
1. Remove the fuse cover and fuse.
2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the
fuse cover.
3. Replace fuse cover.
Green and Yellow to Earth
A
Blue to Neutral
Brown to Liv e
13 Amp fuse
Cord Clamp
21
Hide quick links:
Advertisement
Table of Contents
