Installation Into The Cabinet - CDA FW925 Installation, Use And Maintenance Manual

be drawn over the compressor & heat exchange. A decorative grille
is supplied with the appliance to finish this vent neatly. Alternatively
the required air flow can be achieved by removal of a thin section of
plinth (recommended 600mm x 10mm minimum).
As a rule, the more air that can get in and out, the better and more
efficient the operation of the product.

Installation into the cabinet

With the help of another individual, or two,
manoeuvre the appliance into the cabinet. There
are two metal plates at the base of the appliance.
Fit the supplied white spacers (Fig. 8) to these
plates, as per Fig. 9.
Ensure that the lips of the spacers are level with the lip of the cabinet
base.
Fig. 9
With the base of the appliance aligned correctly with the edge of the
cabinet base, the metal trim at the top of the appliance should sit flush
against the cabinet edge (if it does not, ensure the base is aligned as
per Fig. 9 and that the metal trim in Fig. 10 is not damaged).
Fridge/freezer base
Cabinet base
Floor
x2
Fig. 8
17