progressive automations TY-01 Assembly Instructions Manual page 9

Reset the toP and Bottom position: sometime, you want to reset
9
the top position more higher than original toP position and bottom
position more lower than original Bottom position. You can do
according to the following procedure.
Press uP button on handset and uP button on control box and hold
them together, tV lift moves up. You release these 2 buttons when you
find the new toP position. Press DoWn button on handset and DoWn
button on control box and hold them together, tV lift moves down. You
release these 2 buttons when you find the new DoWn position. now,
you can only move the tV lift from these new toP and Bottom
positions by handset and remote.
tv Lift (tY-01)
AsseMBLY
iNstrUCtioNs
LED
Up Button
Down Button
HOW TO ORDER
1.800.676.6123
sales@progressiveautomations.com
www.progressiveautomations.com
some other information:
10
(1) Frequency study: When you can not find the remote and buy a new
from your local distributor, the frequency of the new remote perhaps
not match with your control box. You should stuDY the frequency
between the remote and control box as following procedure:
Press any button s1 (or s2 and s3) and stuDY button on handset
at the same time and hold them. several seconds later, the leD on
handset will blink and you finish the frequency study. You can use
the new remote to operate this tV lift now.
(2) time protection: in order to prevent from "playing" with the tV
lift, there has time limit protection. You only can operate 3 min-
utes on the tV lift in 20 minutes. if the operation time is too long
(more than 3 minutes), the system will stop to move and leD on the
control box will blink. You should wait for 20 minutes or cutoff the
power of the control box, and then you can operate the tV lift again.
page 8