Wire Size And Terminal Screw Torque; Terminal Door Label; Wiring The Module - Allen-Bradley MicroLogix 1200 User Manual

Wire Size and Terminal Screw Torque

Each terminal accepts up to two wires with the following restrictions:
Wire Type
Solid Cu-90°C (194°F)
Stranded Cu-90°C (194°F)

Terminal Door Label

A removable, write-on label is provided with the module. Remove the
label from the door, mark your unique identification of each terminal
with permanent ink, and slide the label back into the door. Your
markings (ID tag) will be visible when the module door is closed.

Wiring the Module

To prevent shock hazard, care should be taken
ATTENTION
when wiring the module to analog signal sources.
Before wiring any module, disconnect power from
!
the system power supply and from any other source
to the module.
After the module is properly installed, follow the wiring procedure on
page 2-12, using the proper thermocouple extension cable, or Belden
8761 for non-thermocouple applications.
AB Parts
Installation and Wiring
Wire Size Terminal Screw Torque
#14 to #22 AWG 0.904 Nm (8 in-lbs)
#16 to #22 AWG 0.904 Nm (8 in-lbs)
Publication 1762-UM002A-EN-P - July 2002
2-11