Allen-Bradley MicroLogix 1200 User Manual page 131

The 1762-IT4 module is installed in slot 1. To configure the module,
double-click on the module/slot. The general configuration screen
appears.
Configuration options for channels 0 to 2 are located on a separate tab
from channel 3, as shown below. To enable a channel, click its Enable
box so that a check mark appears in it. For optimum module
performance, disable any channel that is not hardwired to a real input.
Then, choose your Data Format, Input Type, Filter Frequency, Open
Circuit response, and Units for each channel.
For a complete description of each of these
TIP
parameters and the choices available for each of
them, see Configuration Data File on page 3-4.
AB Parts
Module Configuration Using MicroLogix 1200 and RSLogix 500
Publication 1762-UM002A-EN-P - July 2002
E-5