IBM 5291 1 Operator's Manual page 61

4-2
CORRECTIVE ACTION:
The following illustration shows the position of error information on the status
line. Try to determine the type of information you have and go to the correct
symbol
(0, 0, G,
a,
or
G).
(If you cannot determine the type of error you
have, refer to the IBM 5291 Display Station Keyboard Template, GX21-9410 for
the Model 1 or the IBM 5291 Model 2 Keyboard Template, GX21-9501. The
template can be held up to the screen and used as a
gui~e
in determining
what types of error information are displayed.)
Engineering Code Field
Stuck Key Field
(See
a.)
(See
G.)
-------------~--.-~
PNXXXXXXXECXXXXXX
.1
o
00-05:
Normal operation. Ignore this position.
06-99: Verify Terminator switch setting and check work station
cables. Contact your system operator and check the Terminator switch
setting on your display station and all other work stations on your cable.
(Refer to the IBM 5291 Display Station Setup Procedure, GA21-9408 for
the Model 1 or the IBM 5291 Model 2 Display Station Setup Procedure,
GA21-9802.) Also check that all work station cables are tight. Then set
the Power switch to Off, wait 10 seconds, then set the Power switch to
On.
o
0-6: Address s'Nitch setting. Normal operatipn. This number should
match the address of your display station. Contact your system operator
for your display station address and reset the Address switches on your
display station if these numbers do not match. (Refer to the IBM 5291
Display Station Setup Procedure, GA21-9408 for the Model 1 or the IBM
5291 Model 2 Display Station Setup Procedure, GA21-9802.) After
resetting the Address switches, set the Power switch to Off, wait
10 seconds, then set the Power switch to On.
7:
Invalid Address switch setting. Contact your system operator and
ask for assistance in resetting the Address switches on your display
station. (Refer to the IBM 5291 Disr-ay Station Setup Procedure,
GA21-9408 for the Model 1 or the IBM 5291 Model 2 Display Station
Setup Procedure, GA21-9802.) After resetting the Address switches, set
the Power switch to Off, wait 10 seconds, then set the Power switch to
On.