Remote Control Panic Alarm; System Components; Valet Switch; Override/Programming Button - Code Alarm PRO 3500 Operator Instructions Manual

i
[
')'<
I •
REMOTE CONTROL PANIC ALARM
When activated the remote control panic alarm will sound the siren continuously and flash
the parking lights for 30 seconds.
To activate the panic alarm, press the button(s) indicated on the remote control transmitter
operating instruction card. The panic alarm can be shut off by pressing any button on the
remote control transmitter. The panic alarm can be activated when the security system Is
armed or disarmed.
SYSTEM COMPONENTS
VALET SWITCH
The valet switch is used for turning the
valet mode on and off. Valet mode
prevents the security system from arming,
yet allows the convenience functions (door
lock
&
unlock, etc.) to operate normally.
Valet mode is useful when valet parking,
fueling or servicing your vehicle.
To use the valet mode, disarm the security system and
toggle the valet switch to the on position.
The status Indicator
will
begin blinking In
a
double flash
pattern to confirm security system ;s in valet mode.
To re-enter the normal operating mode, toggle the
valet switch to the off position.
The status Indicator will tum off, Indicating the system
Components mounted In
vehicles Interior
NOTE: .
The locations shown In this drawing may nol
be the actuallocallon of the components In
your vehicle.
is now in the normal operating mode. Turn the Ignition ON then OFF to reset the
automatic arming timer or arm the system using the remote control transmitter.
OVERRIDE/PROGRAMMING BUTTON
:
The Override/Programming button is a hidden push button switch that can
be used to disarm the security system
if
your remote control transmitter is
lost or stolen. However, the override/programming button is more commonly
used for programming new remote control transmitters to the system (see
"Adding and Deleting Remote Control Transmitter Codes" on the remote
control transmitter operating instruction card) .
. To prevent unauthorized use of the override/programming button, the ignition key is also
needed to disarm the system or program transmitters.
Disarming system without the remote control transmitter
To disarm the security system without the remote control transmitter, follow these steps:
1. Enter vehicle (the alarm will begin sounding as soon as the door is opened).
2. Tum the Ignition key to the on position.
3. Press the override button.
4. The security system is now disarmed. 3