Other Useful Information - Code Alarm PRO 3500 Operator Instructions Manual

-
(~
.~
II
11
I
OTHER USEFUL INFORMATION
Low Vehicle Battery?
Should you ever experience a situation where:
• The starter will not engage after the alarm has been disarmed.
• The starter engages and then almost immediately disengages.
These conditions are almost always caused by an weak or defective vehicle battery.
If this happens, press in and hold the override/disarm button while turning the ignition key
to the start position. This will bypass the starter interrupt in the system control module. In
most cases this will allow the car to start. Should this situation continue to occur, have
your vehicle battery and starting system checked out by your mechanic.
System Maintenance
Your security system does not require any specific maintenance except for occasionally
changing transmitter batteries. However, it is suggested that the system be armed and all
protected zones should be checked on regular basis to make sure that they trigger an
alarm cycle. Should the system malfunction In any way, contact your dealer as soon as
possible for service.
Programmable operating characteristics
Many of the security system's operating characteristics can be programmed by your
installer to operate differently, see your security dealer for additional details.
About transmitter range ...
The receiver inside your vehicle security system and the remote control transmitter are
designed together to have an effective operating range of up to 100 feet during normal
conditions. Although at times you will experience range greater than that, there are certain
conditions that will cause the effective transmitter range to be less than you would
normally experience. Atmospheric conditions and radio inter1erence are just a few
examples of the types of interference that can reduce transmitter range.
This device complies with FCC rules part 15. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must
accept any interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compli-
ance could void the users authority to operate the equipment.
7