System Operation; Arming The Security System; Disarming The Security System - Code Alarm PRO 3500 Operator Instructions Manual

SYSTEM OPERATION
Refer to the remote control transmitter operating instruction to identify the transmitter
buttons called out in the sections below.
ARMING THE SEpURITY SYSTEM
Remote Control arming
1. Exit the ~ehicle and close all ent~ points.
2. Press the "ARM" button on the remote control transmitter.
The siren will chirp and the parking lights wJII flash two (2) times indicating that the
system is armed, protecting your vehicle.
Automatic Arming
Automatic arming may entitle you to receive
a
discount on your insurance policy, see your
agent for details.
If the system is not armed manually, by the user, the system will arm automatically when:
1. The ignition key is turned off.
2. One minute has elapsed and all doors are closed.
The siren will chirp and the parking lights will flash two (2) times to indicate that the
system is armed, protecting your vehicle.
The siren only chirps one time when I try to arm the system ...
If the siren only chirps one time when arming the system, check the status indicator.
• If the status indicator is off, there Is a door, hood, trunk or hatch open. The system will
arm after that opening is closed (see "Arming the System When A Protected Entry
Point Is Open" page 5).
• If the status indicator is displaying a "double-flash" sequence, the system is in the
valet mode. The system will arm after the valet mode is disengaged (see 'tyalet
Switch" page 3).
DISARMING THE SECURITY SYSTEM
Press the nDISARM n button on the remote control transmitter.
The siren will emit one long chirp and the parking lights will flash one time to indicate the
system is disarmed.
If
the siren sounds four short chirps, the alarm has sounded while you
where away - See "Disarmlng the System After an Alarm Has
Sounded~
page 6 .
.:r
The system will rearm in one minute unless the ignition is turned on or the system
is placed in the valet mode.
2