Starting - Mitsubishi MOTORS Pajero Owner's Manual

Starting and driving

Starting

Tips for starting
l Do not operate the starter motor continuous-
ly longer than 10 seconds; doing so could
run down the battery. If the engine does not
start, turn the ignition key back to "LOCK"
position, wait a few seconds, and then try
again. Trying repeatedly with the starter mo-
tor still turning will damage the starter mech-
anism.
WARNING
l Never run the engine in a closed or poor-
ly ventilated area any longer than is nee-
ded to move your vehicle in or out of the
4
area. Carbon monoxide gases are odour-
less and can be fatal.
CAUTION
l Never attempt to start the engine by push-
ing or pulling the vehicle.
l Do not run the engine at high rpm or
drive the vehicle at high speed until the en-
gine has had a chance to warm up.
l Release the ignition key as soon as the en-
gine starts to avoid damaging the starter
motor.
l If your vehicle is equipped with a turbo-
charger, do not stop the engine immedi-
ately after high-speed or uphill driving.
First allow the engine to idle to give the
turbocharger a chance to cool down.
4-14
Starting the engine (petrol-powered ve-
hicles)
E00601600811
The starting procedure is as follows:
1. Insert the ignition key and fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal (M/T).
5. On vehicles with M/T, place the gearshift lev-
er in the "N" (Neutral) position.
On vehicles with A/T, make sure the selector
lever is in the "P" (PARK) position.
Vehicles with M/T Vehicles with A/T
6. After turning the ignition key to the "ON" po-
sition, make certain that all warning lamps
are functioning properly before starting the
engine.
7. Turn the ignition key to the "START" posi-
tion without depressing the accelerator pedal,
and release it when the engine starts.
OBKE12E1
NOTE
l
A ticking noise may be heard after starting
the engine. This is not an abnormal condi-
E00601701994
tion. The noise will disappear after a short
time of engine running.
If the ticking noise continues after the engine
is warmed up, we recommend you to have
your vehicle checked.
Using the MIVEC engine
The MIVEC engine automatically switches its in-
take-valve control between a low-speed mode and
a high-speed mode in accordance with driving con-
ditions for maximum engine performance.
NOTE
l To protect the engine, the high-speed mode
may not be selected while the engine coolant
temperature is low. In such a case, the engine
revolutions do not rise to over 5,000 rpm
even if the accelerator pedal is depressed.
Starting the engine (diesel-powered ve-
hicles)
1. Insert the ignition key and fasten the seat belt.
2. Make sure the parking brake is applied.
3. Depress and hold the brake pedal.
4. Fully depress the clutch pedal (M/T).
5. On vehicles with M/T, place the gearshift lev-
er in the "N" (Neutral) position.
E00601800086