Table of Contents
Advertisement
Follow the procedure below to use the product.
4-1 Check the Main Body
• Visual appearance check: Does the main body have flaws
on its appearance due to a fall or others?
• Battery life check: Is a buzz heard for approx. 4 seconds,
and the LED flashes slowly after illuminated?
"4-3 Checking ON/OFF of the Power"
• Are the main body, rubber ring, or hands wet with water?
4-2 Attaching to the Cutting Tool
1) Place the product inside the cable cutter's handle so that
a working hand touches an electrode part.
2) Secure the product tightly with a provided rubber ring in
a correct orientation as shown in the figure below (LED
facing toward the wrist).
* Two different sizes of rubber rings (S/M) are provided. Select a ring
which suits the thickness of the cutter's handle.
* If the product is not secured tight and apparently moving apart or
coming off from the handle, the sensitivity becomes unstable.
(1)
(2)
(3)
Rubber ring
Pull with a finger
— 7 —
Main body
LED
Advertisement
Table of Contents
