Sanwa KDP10 Instruction Manual page 10

4-4 Checking for a normal detection
Check that the product works normally with the tip of the
manual cutter 1 to 2 cm away from the known live-wire cable
after the product is powered ON.
* Grip the cutter so that your hand touches the electrode part inside
the product.
* If the product does not work properly, do not use the product at that
place as the cutter or surrounding environment may have impacted
the product.
Electrode
4-5 Adjusting the Sensitivity Volume
If the detection sensitivity needs to be adjusted, remove
the sensitivity control volume cover, and rotate the knob
with a Phillips-head screw driver. As the factory default, the
sensitivity is set to the maximum.
After the adjustment, place the cover back into position.
* Rotating to the left ("−") decreases the sensitivity (insensitive), and
rotating to the right ("+") increases the sensitivity (sensitive).
Known live-wire cable
— 9 —
Low High
Sensitivity
control
volume
Knob