Maintenance; Replacing The Batteries - Sanwa KDP10 Instruction Manual

4-6 Using the Tool for Work
Approach the cable cutter with the product attached to the
live-wire cable.
* If you hear a buzz and the LED flashes, stop cutting the cable. Use a
voltage detector or multimeter to check if it is a live-wire or not, then
resume the work.
* Turn OFF the product after use.

[5] MAINTENANCE

5-1 Instructions on Cleaning and Storage
• Do not use a thinner or alcohol to wipe and clean the product as it is
weak against a volatile solvent. Wet a lint-free soft cloth with water and
wipe the dirt off.
• As the product is weak against heat, do not place it close to an object
which generates heat.
• Do not store the product in a place where it is prone to shake or may
fall.
• Do not store the product under a direct sunlight, high temperature, low
temperature, humid, or dew-condensed environment.
• Be sure to remove the batteries if the product will not be used for a
long time.
• Comply with local regulations when disposing or treating the product
and coin batteries.

5-2 Replacing the Batteries

If the power is turned ON with the low voltage of internal
batteries, you are warned with a buzz and LED as shown
below. Replace both of the batteries.
A buzz and LED illumination (for approx. 4 seconds)  LED
slowly flashing
NOTICE
— 10 —