How To Use - Sanwa KDP10 Instruction Manual

[4] HOW TO USE

This product and a manual cutter with the product attached is not
a voltage detector. Use a voltage detector or multimeter for voltage
detection. May cause a fire or an electric shock.
Ensure that you wear a "protective equipment" before use. May
cause an electric shock.
• This product is intended for a general 7"/8" manual cable cutter. The
product may not be available for some cutters.
ƒ Situations where correct detection is not possible
• A live-wire may not be detected if the size of sensitivity
volume is too low.
"4-5 Adjusting the Sensitivity Volume"
• The product is exclusively for a commercial power's
alternate voltage (frequency: 50 Hz/60 Hz), A circuit
with a different frequency, for example, secondary
voltage of an inverter, cannot be detected.
• A live-wire may not be detected depending the
surrounding environment, and how the product is
attached or gripped.
• When a human body is touching the metallic tip of the
cutter or the sheath of the cutter's handle is thin, in
principle, it is difficult for a signal to run through the
product, which potentially disables the detection of a
live-wire.
• A detection sensitivity decreases when a target live-
wire cable is touching a human body.
• A live-wire cannot be detected on a shielded cable
because the product cannot detect an electric field.
• An electric field of an adjacent live-wire cable may be
detected.
DANGER
NOTICE
— 6 —