Installing Other Software; Example Programs - National Instruments USB-9211A User Manual

Installing Other Software

Note If your device uses NI-DAQmx Base, refer to

Example Programs

Installing the NI USB-9211/9211A Device
Installing the NI 9211 in the NI USB-9161/9162 Carrier
NI USB-9211/9211A User Guide and Specifications
If you are using other software, refer to the installation instructions that
accompany your software.
The NI-DAQmx CD contains example programs that you can use to get
started programming with the NI USB-9211A. Refer to the NI-DAQmx for
USB Devices Getting Started Guide that shipped with your device, and is
also accessible from Start»All Programs»National Instruments»
NI-DAQ, for more information.
The NI-DAQmx Base software ships with example programs you can use
to get started programming with the NI USB-9211/9211A. Refer to the
NI-DAQmx Base Getting Started Guide that shipped with your device, and
is also accessible from Start»All Programs»National Instruments»
NI-DAQmx Base»Documentation, for more information.
Before installing the device, you must install the software you plan to use
with the device. Refer to the
and the documentation included with the software for more information.
The NI 9211 module and the NI USB-9161/9162 carrier are packaged
separately. Refer to Figure 3, while completing the following assembly
steps:
1. Make sure that no signals are connected to the NI 9211 module and the
USB cable is not connected to the device.
2. Remove the protective cover from the 15-pin D-SUB connector.
ni.com
Installing the Software
8
to download the software.
section of this guide
ni.com