Installing The Software; Installing Other Software; Example Programs - National Instruments NI USB-9234 User Manual

Installing the Software

Installing Other Software

Example Programs

Installing the NI USB-9234 Device
Installing the NI 9234 in the NI USB-9162 Carrier
© National Instruments Corporation
Software support for the NI USB-9234 for Windows Vista/XP/2000 is
provided by NI-DAQmx. The DAQ Getting Started Guide, which you can
download at
ni.com/manuals
instructions for installing software and hardware, configuring channels and
tasks, and getting started developing an application.
If you are using other software, refer to the installation instructions that
accompany your software.
The NI-DAQmx CD contains example programs that you can use to get
started programming with the NI USB-9234. Refer to the NI-DAQmx for
USB Devices Getting Started Guide that shipped with your device, which
is also accessible from Start»All Programs»National Instruments»
NI-DAQ for more information.
Before installing the device, you must install the software you plan to use
with the device. Refer to the Installing the Software section of this guide
and the documentation included with the software for more information.
The NI 9234 module and NI USB-9162 carrier are packaged separately.
Refer to Figure 3, while completing the following assembly steps:
1. Make sure no signals are connected to the NI 9234 module and the
USB cable is not connected to the device.
2. Remove the protective cover from the 15-pin D-SUB connector.
, offers NI-DAQmx users step-by-step
7 NI USB-9234 User Guide and Specifications