Inputs And Outputs; Input Channels; Output Channels; Communication Channels - Bosch DDU 9 Manual

7 | Inputs and Outputs

20 / 148
7 Inputs and Outputs

7.1 Input channels

Analog inputs
The DDU 9 analog inputs accept an input signal of 0 to 5 V. A 3.01 kOhm pull-up resistor
can be activated by software.
Digital inputs
The digital inputs of the DDU 9 accept 0 V to 5 V signals of Hall-effect sensors by default.
Connect the output of the Hall-effect sensor to the REVn_P pin and leave the REVn_M pin
open.

7.2 Output channels

Sensor power supply
The DDU 9 has four sensor power supplies:2 x 5 V, 1 x 10 V and 1 x Ubat regulated
voltage. They are short circuit protected to battery voltage and GND.

7.3 Communication channels

CAN bus
The DDU 9 has two CAN buses configurable as input and output. Different baud rates are
selectable. Please note that the DDU 9 does not contain any CAN termination resistors.
Thus the CAN termination resistors need to be integrated into the wiring loom.
Ethernet channels
The DDU 9 has one 100 MBit full duplex Ethernet communication ports. The port is intern-
ally connected with an Ethernet switch. The Ethernet ports have 'cable auto crossover'
functionality.
RS232 ports
The DDU 9 has two RS232 serial ports. Baud rate for both ports is programmable. RS232
port 1 is reserved for online telemetry, port 2 can be used for reception of data from a
serial GPS receiver.
Vehicle diagnosis connector
The Bosch Motorsport vehicle diagnosis connector is used as a standard interface to con-
nect the vehicle to a PC e.g. via a MSA-Box II. Loom connector: AS 0-12-35SN
Pin Name
Pin 1 Terminal 30
Pin 2 Terminal 15
Pin 3 Terminal 31
Pin 4 CAN High
Pin 16 CAN Low
Description
Permanent positive
Switched positive
GND
Diagnostic CAN bus
Diagnostic CAN bus
DDU 9
Used for DDU 9
+
+
+
Bosch Motorsport