Pan Detection; Indication Of Residual Heat; Power Function - Novy 1801 Operation Instructions Manual

Switching a cooking zone on and off
Set up
Press the cooking zone selection button.
Switch off
Press the cooking zone selection buttons
and simultaneously until the display shows
or = "hot".
0 H
If there is no control input within 20 seconds, the electronics will
return to the wait position.

4.1.3 Pan detection

The cooking zone that has been switched on is only active
when a cooking pan is detected by the pan detection system.
The induction hob does not work:
– If there is no pan on the cooking zone or if the pan is
unsuitable for induction. In this case, it is impossible to put
the power on and the symbol will flash on the display.
– The operation is suspended when the pan is removed from
the cooking zone during cooking. The
on the display. The symbol will disappear when the pan is
placed back onto the cooking surface. The cooking will then
continue at the same power level as selected previously.
Switch off the cooking zone after use.

4.1.4 Indication of residual heat

After the cooking zone or hob has been switched off completely,
the hob glass will still be warm, which can be seen by
symbol disappears when the cooking zone glass can be
H
handled without danger.

WARNING: As long as the residual heat indication
remains active, the cooking zone(s) must not be
touched and no heat-sensitive items should be
placed on the cooking zone. Risk of fire and burns.

4.1.5 Power function

Power function boosts the power to the selected cooking
P
zone. If this function is activated, these cooking zones will be
subjected to considerably higher power for 10 minutes.
The Power function is designed to quickly heat large quantities
of water, for pasta for example.
Switching Power on and off
Switch on power
Press the cooking zone selection button.
Press the button and then the
until P
Switch off Power
Press on the button
Display
00
0
H
symbol will flash
. The
H
Display
P
button
9‐0
– 60 –
Management of maximum power:
The hob is divided into 2 separate heating groups.
B2
B1
B2
B1
If this power limit is exceeded when switching to a high
selected cooking heat or switching the power function on, the
power management module reduces the cooking position of
the relevant cooking zone. This cooking zone will first flash,
and it is then automatically reduced to the maximum possible
cooking heat
Het maximale vermogen van de zones A1 en B2 is afzonderlijk
3000W en 1850W van de zones A2 en B1.
If simultaneous cooking is taking place on zones A1 and A2 or
B1 and B2, the power of 3700 W is divided between these 2
zones A1 and A2 or B1 and B2.
Cooking zone in cm
A1 24 x 20
B2 24 x 20
B1 24 x 20
A2 24 x 20
Power limit
Selected cooking zone with Power function
Power limit activated
[9] reduced to [8] and flashes
In order to be able to make use of the maximum possible power
for 2 zones at the same time, use a combination of zone A1 or
A2 and B1 or B2.
A2
A1
A2
8 8
8 8
A1
Power (W)
Normal: 2100
Power: 3000
Normal: 1600
Power: 1850
Display
P
8