Table of Contents
Advertisement
Getting started
Adding and registering a handset
You can add a new handset to your telephone system, but it must be registered
with the MS2085 console or MS2025 deskset before use. Each MS2085 or MS2025
supports one cordless handset. When first purchased, the expansion handset
shows Choose Handset in Registration at base menu. And put handset on
cradle to register.
If the handset does not have enough power to proceed with the registration, you
need to charge the new handset for at least five minutes (see Battery installation
and charging on page 6). Start registration when the handset screen shows
Choose Handset in Registration at base menu. And put handset on cradle to
register.
To register a handset to a MS2085 console
1.
Make sure the cordless handset is out of the charger and the screen
shows Choose Handset in Registration at base menu. And put handset
on cradle to register.
2.
On the MS2085 console, press MENU
3.
Scroll down to Registration and press
4.
Press
SELECT again to select Handset. The MS2085 console screen
MENU/
shows Registering handset... (Put handset on cradle to start).
5.
Place the unregistered handset into the charger. The handset beeps once
and begins registering to the MS2085 console. It takes up to
to complete the registration. There is a beep sound when the registration
is successful. The MS2085 console shows Handset registered and then the
handset shows EXT XX (X represents the extension number).
NOTES:
•
If the registration is not successful, the console screen displays Registration failed with an
error tone. To reset the handset, remove the handset from the charger. Try the registration
process again.
•
Make sure to remove all unregistered system handsets or cordless headset from the charger
before registering a new handset.
/SELECT.
SELECT.
MENU/
8
60 seconds
Advertisement
Table of Contents
