Table of Contents
Advertisement
Announces
"Memory
is full"
Cannot
access
Remote Operation
TECHNICAL INFORMATION
This cordless phone uses radio frequencies to allow mobility. There are certain difficulties in
using radio frequencies with a cordless telephone. While these are normal, the following could
affect the operation of your system.
NOISE: Electric pulse noise is present in most homes at one time or another. This noise is
most intense during electrical storms.
dimmers, fluorescent bulbs, motors, and fans also generate noise pulses.
frequencies are susceptible to these noise pulses, you may occasionally hear them in your
handset. Generally, they are minor annoyances and should not be interpreted as defects in
your system.
RANGE: Because radio frequencies are used, location of the base unit can affect operating
range. Try several locations in your home or business and pick the one that gives you the
clearest signal.
INTERFERENCE: Some electronic devices operate in and/or generate interference near the
operating frequencies of your cordless telephone. While several protection circuits are used to
prevent unwanted signals, there may be periods when these unwanted signals cause
interference. If interference occurs frequently, it can be minimized or eliminated by lowering the
height of your base antenna or by relocating the base unit. You can check for interference
before selecting the final base unit location by plugging in the phone.
ADAPTER: Use Only Class 2 Power Source 9VDC 850mA.
Distributed Exclusively Worldwide by Unical
Enterprises, Inc., City of Industry, California, USA
35818/05xxxx-x
•
Check to see if the Answer mode is not set in the Answer Off
mode.
•
The 13 minutes recording limit may have been reached or 59
messages are stored in memory. Erase old messages to make
room for new messages.
•
The remote PIN code you entered may be incorrect. Enter the
correct PIN code during OGM playback or ICM recording
status, you must finish the second and third digit input within
8seconds of inputting the first digit.
•
Use Touch Tone (DTMF tone) telephone only to access
Remote Operation. Ensure that you press and hold each key
press for at least 2 seconds for each digit.
Certain kinds of electric equipment such as light
http://www.nwbphones.com
Because radio
Advertisement
Table of Contents
