Table of Contents
Advertisement
TURNING THE ANSWERER ON/OFF
You may turn the answerer on/off by pressing button on base unit, issue command during line
remote mode or handset remote mode. For operations during remote modes, please refer to
remote section for detail operation.
1.
During Standby mode, press the ANS ON/OFF button on the base unit to turn on the
answerer, you will hear "Answer on" from the speaker as indication;
2.
Press the ANS ON/OFF button again to turn off the answerer, you will hear "Answer off"
from the speaker as indication.
NOTE: Once turned off, the answerer will answer only after the 10
the answerer on or listen to the message stored from a remote location.
SETTING THE RING COUNT
During answer on mode, the answerer will answer the call after the number of rings set in the
ring count option menu by the user. Please refer to the TAD RING COUNT section of the
"PHONE SETUP OPERATION" chapter for setup details.
If "3" is selected, the answerer will answer the call after 3 rings;
If "5" is selected, the answerer will answer the call after 5 rings;
If "TS" is selected, the answer will answer the call after 3 rings if there is new message(s) in the
memory or after 5 rings if there is no new message in the memory, this will save money for
making call from a remote location pay phone because you can hang up the call at the 4
in case no new message to listen to.
SETTING REMOTE PIN CODE
There is a remote access PIN code, a 3 digits code, which is required for taking remote to the
answer when calling from remote telephone. The default PIN code is "777".
1.
During Standby mode, press the handset REMOTE button to enter handset remote mode;
2.
Press the * button to enter PIN setup screen, the LCD screen shows "ENTER TAD PIN"
and the current PIN is shown on the LCD screen;
3.
Press 3 digits (from 0~9) new code to enter your new code;
4.
Press REMOTE button again to save the new PIN to the base answerer.
NOTE: If you forgot your PIN, press REMOTE and then * on handset to check current PIN.
NOTE: you can also set this PIN on the base unit "TAD PIN SETUP" setup menu. Please refer
to "PHONE SETUP OPERATION" for detail.
RECORDING A MEMO
You can leave a message to your family member(s) by recording a MEMO message locally.
1.
During Standby mode, press and hold the MEMO button to record MEMO message,
the answerer will prompts "Please record message after the tone";
2.
Then release the button and start speak to the microphone when a beep tone is heard;
3.
Press the STOP button when MEMO recording is completed, the message counter (7-
segment LEDs) will be increased by one.
NOTE: The MEMO message(s) is stored in the same message memory as the ICMs, and is/are
played back together with the ICMs during playback mode.
NOTE: The maximum MEMO recording time per message is 2 minutes.
PLAYING OF MESSAGE/MEMO
During Standby mode, press the PLAY button on base unit to start playback the message(s). If
there is new message in memory, all new messages will be played back during this round. If
there is no new message in memory, all messages will be played back during this round.
Oldest message will be played first.
th
ring, allowing you to turn
th
ring
Advertisement
Table of Contents
