When The Memory Is Full; Improving Cordless Reception; Maintenance; Troubleshooting - Bell Phones Excursion 35818 Manual

Table of Contents

Advertisement

screened.

WHEN THE MEMORY IS FULL

The answerer can record 13 minutes or 59 messages at most. When memory is full, you will
hear the voice prompt "MEMORY IS FULL" if you are trying to record new OGM/MEMO/ICM or
when you enter the line/handset remote mode.
You must delete some old messages in order to make room for new messages.

IMPROVING CORDLESS RECEPTION

Follow these guidelines to improve cordless sound quality:
Select an area to install the 35818 where it is closest to the center of your home or office.
This will improve the operating range of the unit.
Keep the 35818 base unit away from electrical equipment. Radio Frequency Interference
(RFI) is sometimes generated by these appliances, which can cause degradation in
cordless reception.
Keep the handset batteries charged as much as possible. Weak handset batteries can
limit the range of cordless operation.

MAINTENANCE

1.
Your phone should be situated away from heat sources such as radiators, heaters, stoves
or any other appliance that produces heat.
2.
Use a slightly damp cloth to clean the plastic cabinet. A mild soap will help to remove
grease or oil. Never use polish, solvents, abrasives or strong detergents since these can
damage the finish.

TROUBLESHOOTING

A. TELEPHONE UNIT TROUBLESHOOTING TABLE
Symptoms
No dial tone
Does not ring
No power on the
handset unit
Possible Solution / Cause
Check that the telephone line cord connectors at both ends are
pushed in firmly until they click.
Check the ringer volume mode on the handset. Set to ringer
hi/med/lo mode to enable the handset ringer.
Check that the telephone line cord connectors at both ends are
pushed in firmly until they click.
You may have exceeded the Ringer Equivalence Number
(REN) limit of how many phones can be connected to the
same line. The REN total of all devices (printed on the bottom
label of each unit) should not exceed five (5). Disconnect the
appropriate units to lower the REN total.
Check the Ni-MH battery pack for proper connection inside the
battery compartment on the handset.

Advertisement

Table of Contents
loading

Table of Contents