Answerer Operation; Setting The Day/Time Stamp; Recording Your Outgoing Message; Checking Your Outgoing Message - Bell Phones Excursion 35818 Manual

Table of Contents

ANSWERER OPERATION

This is a sophisticated Digital Answerer incorporated in this cordless system. All incoming

messages (ICMs), outgoing message (OGM) and Memo messages (MEMO) are stored digitally

into non-volatile memory. Messages are accessed instantly and arranged compactly in this

memory. The answerer can store 13 minutes of messages or 59 messages at most (ICMs,

OGM and MEMOs combined).

You need to set the day/time at every power up of the base unit, otherwise there will be no

day/time stamp announcement for message playback. Please refer to the TAD DAY/TIME

section of the "PHONE SETUP OPERATION" chapter for setup details.

The base unit day/time row will blinks slowly if use had not complete this setup.

Before using your Answerer, it is suggested that you record your own Outgoing Message

(OGM). This is the announcement callers will hear when the system answers a call.

During Standby mode, press and hold the OGM button to record your own OGM, the

answerer will prompts "Please record announcement after the tone";

Then release the button and start speak to the microphone when a beep tone is heard.

The 7-segment LEDs will shows the countdown time of the OGM recording, 29,28,27,...;

Press the STOP button when OGM recording is completed. The updated OGM will be

played back from the speaker immediately for your approval.

NOTE: Maximum OGM recording time is 30seconds.

NOTE: To obtain a better sound quality for locally recorded messages, speak directly into the

microphone from a distance of 9 to 12 inches.

To check and playback your current outgoing message.

During Standby mode, press the OGM button to check the current OGM in use;

The current OGM will be played back from the speaker immediately.

The restore the current OGM to prerecorded system announcement.

During Standby mode, press the OGM button to play the current custom OGM;

During playback, press the ERASE button to erase the custom OGM thus the default OGM

is restored and played back to you immediately "Hello, Please leave a message after the

tone".

Table of Contents