Bell Phones Excursion 35818 Manual page 16

5. Press numeric keypad to enter time in 12hour format;
6. Press UP or DOWN button to select AM/PM;
7. Press MENU button to save the setting;
8. Press BACK button to go back to Standby mode.
NOTE: if day/time is not set, the LCD lower row will blinking and dual 7segment LED digit will
shows "CL", and no day/time stamp for those message(s) recorded during day/time is not set.
You must input the day/time again if A/C power interruption is occurred.
TAD PIN SETUP (applicable to base unit only)
This TAD allows you to input your desired TAD remote PIN code. This PIN code is used when
call in to operate the TAD from a remote phone.
1. During Standby mode, press MENU button;
2. Press DOWN button until "
3. Press MENU button;
4. Press 3 digits new PIN code (Preset PIN code is 777);
5. Press MEUN button to save the setting;
6. Press BACK button to go back to Standby mode.
DELETE VMWI (applicable to base unit only)
This telephone allows you to force the VMWI indicator to off (stop blinking only, not to turn off
VMWI feature) if desired.
1. During Standby mode, press MENU button;
2. Press DOWN button until "
3. Press MENU button to confirm;
4. The screen shows "
immediately;
5. Press BACK button to go back to Standby mode.
LOAD DEFAULT
This telephone allows you to restore the phone setup options back to factory default. The Load
Default action will cause Menu Language back to English, Ringer Volume back to Medium,
Ringer Tone back to Tone 1, Area Code erased, Tone/Pulse mode back to Tone, Auto Answer
back to Disable, handset ear piece volume back to Vol.2, base speakerphone volume back to
Vol.4, TAD ring count back to Toll Save, TAD PIN back to 777, TAD status back to Answer On.
1. During Standby mode, press MENU button;
2. Press UP button;
3. Press MENU button;
4. Press UP button to select YES;
5. Press MENU button to confirm Load Default;
6. Press BACK button to go back to Standby mode.
TAD PIN SETUP
" option is pointed by the pointer;
DELETE VMWI
VMWI DELETED! " and the VMWI indicator will stops blinking
" option is pointed by the pointer;