Table of Contents
Advertisement
2.
Press digit button 0~4 to input destination extension number (extension 0 is the base unit,
extension 1~4 is the handsets).
3.
Destination handset/base unit beeps, the destination unit will shows "
BASE
", the page signal will last for 2minutes and then stops.
PAGING AND INTERCOM WITH OTHER HANDSET/EXTENSION
1.
Press INT button on handset (or INT button on the base unit).
2.
Press digit button 0~4 to input destination extension number (extension 0 is the base unit,
extension 1~4 is the handsets).
3.
Destination handset/base unit beeps, the page signal will last for 2 minutes.
4.
If user presses the INT button on destination extension unit during paging, it will bring both
units into Intercom mode.
5.
When finish with the Intercom, press INT button on handset/base unit will end the Intercom
mode.
RING ON INTERCOM
1.
During Intercom mode, if there comes an incoming call, caller ID will display on the screen
2.
Short beep alert will be heard.
3.
Any user can press TALK button on handset (or SPEAKER button on base unit) to end the
Intercom and take the call.
4.
If the intercom handset is replaced to cradle, the Intercom will be ended and the handset
starts ringing.
QUICK TRANSFER CALL TO OTHER HANDSET/EXTENSION
1.
During a call, the user can press the INT button followed by destination handset/extension
number 0~4 (extension 0 is the base unit, extension 1~4 is the handsets).
2.
Press TALK button on handset (or SPEAKER button on base unit) to end and the call is
quick transferred to the destination extension, it starts ringing and shows like "
FROM HANDSET 1
3.
If destination extension user does not answer the call within 30 sec, source extension will
be ring back for another 30 sec.
TRANSFER CALL AFTER INTERCOM
1.
During a call, the user can press the INT button followed by destination handset/extension
number 0~4 (extension 0 is the base unit, extension 1~4 is the handsets).
2.
If destination extension user presses the INT button to answer the intercom request,
Intercom mode is setup and the call is on hold.
3.
After the Intercom, user can press the TALK button (or SPEAKER button for base unit
case) on source extension to end the Intercom and the call is taken by the destination
extension automatically.
CONFERENCE WITH LINE
1.
During a call, the user can press the INT button followed by destination handset/extension
number 0~4 (extension 0 is the base unit, extension 1~4 is the handsets).
2.
If destination extension user presses the INT button to answer the intercom request,
Intercom mode is setup and the call is on hold.
3.
In Intercom mode, user can press the CONF button on source extension to get the
destination extension into the Conference mode with the external line. After Conference,
any extension can quit the Conference by pressing TALK button (or SPEAKER button for
base unit case).
MIXED MODE DIALING (Temporary Pulse to Tone Dialing)
1.
If you only have pulse (rotary dialing) service in your area and want to access Tone
services (Phone banking service, etc.), ensure that the signaling mode setting in the
phone setup menu is set to Pulse mode.
2.
Press the */TONE button once to switch from Pulse to Tone dialing temporarily, Pulse
dialing mode resumes when the call is ended.
PAUSE FUNCTION
•
In some cases, such as PBX or long distance service, a pause may be needed in the
dialing sequence. Pressing the PAUSE button inserts a four-second delay between dialed
".
PAGING FROM
TRANSFER
Advertisement
Table of Contents
