Table of Contents
Advertisement
2. Fasten the lap/shoulder belt latch
into the buckle, until you hear a
"clicking" sound.
Make sure that the release button is
easily accessible in case of an emer-
gency.
3. Pull the entire shoulder portion of
the seat belt from the retractor.
When the shoulder portion of the
seat belt is fully extended, the belt
system
will
shift
"Automatic
Locking"
restraint) mode.
4. Slowly allow the shoulder portion
of the seat belt to retract, until you
hear a "clicking" or "ratcheting"
sound. This indicates that the
retractor is set in the "Automatic
Locking" mode. When you do not
hear any "clicking" sound, repeat
the steps 3 and 4.
Safety system of your vehicle
5. Tighten the belt as secure as pos-
sible by slightly tugging it on the
child restraint, while retracting the
shoulder portion of the belt back
into the retractor.
6. Slightly push and pull the child
OBH039102
restraint to confirm its firm installa-
tion. If not, release the seat belt,
and repeat the steps 2 to 6.
7. Double check that the retractor is
in the "Automatic Locking" mode
into
the
by slightly pulling the seat belt out
(child
of the retractor. If unstretched, the
seat belt is set in the "Automatic
Locking" mode.
To remove the child restraint, press
the release button on the buckle, pull
off the lap/shoulder belt from the
restraint, and then fully retract the
belt.
OBH039103
02
OEN036104
2-37
Advertisement
Chapters
Table of Contents
