Table of Contents
Advertisement
Safety system of your vehicle
CAUTION
Never allow anyone to take a
seat, of which a head restraint is
removed.
Reinstall
To reinstall a head restraint:
1. Raise a head restraint to the high-
est by pressing up the switch (1).
2. Put the poles of the head restraint
(2) into the holes. Then, pull down
the switch (3) until the head
restraint lowers to the lowest.
3. To securely install the head
restraint, raise and lower the head
restraint 2 or 3 times by pressing
the switch.
4. Recline the seatback (5) by press-
ing the recliner control switch (4).
5. Adjust the head restraint to the
appropriate height.
NOTICE
Do not attempt to reinstall a head
restraint from the incorrect height,
other than from the highest. Do not
force it. It causes damage to the
head restraint.
2-8
• When a head restraint is not
securely installed, a head
restraint may not normally
and actively operate. When
reinstalling a head restraint,
securely latch it, as instructed
in the procedures.
• Always confirm that a head
restraint is fully latched in the
right
stalling it.
• Do not operate the vehicle,
when a head restraint is
removed, as severe injury to
an occupant may occur in the
event of an accident. A head
OVI035102N
restraint may provide protec-
tion against neck injuries
when properly adjusted.
WARNING
position, after
rein-
Advertisement
Chapters
Table of Contents
