Fault Finding Guide - Malmet Energy Saver ES910 Operation, Maintenance And Installation Manual

Bedpan Washer Disinfector - Energy Saver
Detergent Model With Hands Free Operation
Operation, Maintenance and Installation Manual

Fault Finding Guide

The unit is controlled by a sophisticated micro-processor. The processor has fault detection capability and
indicates faults by code on the digital display; Table B1 indicates these faults. For a more detailed
description of these fault conditions see Appendix A – Faults.
Fault No.
01 Door Open Fault – Not Confirmed Door Closed
02 Wash / Disinfection Cycle Time Out
03 Fault Hot Water Probes
04 Door Motor Activation Time Out
06 Hot Water Tank Fill Time Exceeded
07 Hot Water Tank Low Water Level Sensed During Cycle
08 Door Closure Fault – Not Confirmed Door Open
09 Failed To Reach Disinfection Start Temperature Resulting In Time Out
10 Disinfection Temperature Not Maintained Resulting In Cycle Time Out
12 Hot Tank Short Circuit Temperature Sensor
13 Hot Tank Open Circuit Temperature Sensor
14 Disinfection Chamber Short Circuit Temperature Sensor
15 Disinfection Chamber Open Circuit Temperature Sensor
Note: If a fault is displayed on the LED display, turn unit off and turn it back on, press START to try to
complete a cycle. If a fault persists contact a service person. Record the fault code that has
appeared for the Service Technician
Issue 21
Description
Table B1
Page 20 14 September 2017