Rize MULTI-FLEX Owner's Manual page 10

Wireless Hand
Remote Programing
(1 Hand Control and 1 Bed)
Note:
Programming by the user is only needed on replacement remotes.
1. Insert batteries into the
Hand remote control (2x
2. Make sure your adjustable bed is plugged into
a working grounded outlet or surge protector.
3. Hold down the learn button for 3 seconds.
4. The LED signature light will illuminate.
This means the RF frequency code setting
function has been activated.
6. When the receiver light flashes, the RF
frequency code learning process is complete.
1. Follow steps 1 through 6 above for 1 hand control and 1 bed.
2. Repeat the steps for the other bed using the same hand control.
batteries).
Figure 2:
The red LED
will light up
when the
control box
is in the
learning
mode.
"MULTI-FLEX"
The
Wireless Hand Remote Programing
(1 Hand Control and 2 Beds)
The "MULTI-FLEX"
Wireless djustable Bed
5. Press any button
on the remote
control
Figure 3:
Hand held
remote control
F
igure 1:
Press the
"Learn Button"
to initiate the
RF learning
.
mode
F
igure 4:
flashing red
LED indicates
the control
box has
received
the remote
control figure
8