If you are uncertain about use of the valve or its suita- bility for your intended purpose, please contact Fig. 2 Identification plate example Metso’s Automation business for more information. Markings on the identification plate: Valve construction Body and bonnet material Series ZX valves are flanged rotary control valves.
It can be material. Most parts have a material marking. A material measured or calculated using the Metso Nelprof soft- list is supplied with the valve. In addition, separate ware. Observe the relevant working environment regu- recycling and disposal instructions are available from lations in terms of noise emission.
1 RG 70 en TRANSPORTATION, RECEPTION AND STORAGE Check the valve and the accompanying devices for any damage that may have occurred during transport. Store the valve carefully before installation, preferably indoors in a dry place. Correct Fig. 4 Installing the control valve into pipeline using supports Do not attempt to correct a pipeline misalignment by means of flange bolting.
1 RG 70 en ❑ Gland packing adjustment Fasten the gland with the nuts (18) and tighten them according to Table 1. In the event of a packing leakage tighten the gland nuts ❑ Remove the old bonnet seal (66) from the body, (18) in ¼...
The actuator is attached to the valve via an ISO 5211 seal (66). Do not scratch the sealing surfaces. standard mounting interface. Several types of Metso ❑ Clean the cage cavity of the body.
1 RG 70 en TYPE CODE RotaryGlobe Control Valve, Series ZX L060 VALVE SERIES, CONNECTION AND TRIM FACE TO FACE LENGTH VALUES FOR SIZES DN 15 - DN 25 / ½"-1" RotaryGlobe valve, flanged, f-to-f length acc. to ISA S75.03 TRIM DESCRIPTION and EN 558-2 series 37-39...
Page 16
1 RG 70 en Metso Automation Inc. Europe, Levytie 6, P.O. Box 310, 00811 Helsinki, Finland. Tel. +358 20 483 150. Fax +358 20 483 151 North America, 44 Bowditch Drive, P.O. Box 8044, Shrewsbury, MA 01545, USA. Tel. +1 508 852 0200. Fax +1 508 852 8172 Latin America, Av.