Displaying Vdsl Information; Table 29-9 Commands For Displaying Vdsl Information - SMC Networks TigerAccess SMC7816M Management Manual

Displaying VDSL Information

This section describes the commands used to display information on
VDSL configuration settings, signal status, and communication statistics.

Table 29-9 Commands for Displaying VDSL Information

Command
Displaying Configuration Settings
show lre band-plan
show lre
option-band
show lre ham-band
show lre
region-ham-band
show lre psd
show lre
psd-mask-level
show lre pbo-config Displays the mask used to reduce the power
show lre upbo
show lre tone
show lre
interleave-max-delay
show lre datarate
Function
Displays the frequency bands used for
VDSL signals
Displays the frequencies to be used for the
optional US0 band
Displays the HAM radio band that is
blocked to VDSL signals based on defined
frequencies
Displays the HAM radio band that is
blocked to VDSL signals based on defined
usage types
Displays the power level set for each of the
PSD breakpoints
Displays the predefined PSD mask
configured for an interface
spectral density (PSD) of transmitted signals
at specified frequency breakpoints
Shows if upstream power backoff is enabled
or disabled
Shows if VDSL signals are enabled or
disabled at frequencies less than or equal to
640 KHz, 1.1 MHz or 2.2 MHz
Displays the maximum interleave-delay for
downstream and upstream channels
Displays the minimum and maximum data
rate for downstream and upstream fast or
slow (interleaved) channels
D VDSL I
ISPLAYING NFORMATION
Mode Page
PE 29-62
PE 29-63
PE 29-64
PE 29-65
PE 29-67
PE 29-68
PE 29-69
PE 29-70
PE 29-71
PE 29-72
PE 29-73
29-61