Figure 9-9 Port Broadcast Control - SMC Networks TigerAccess SMC7816M Management Manual

6-band vdsl2 switch

Hide thumbs Also See for TigerAccess SMC7816M:

Table of Contents

ONFIGURATION

Web – Click Port, Port Broadcast Control or Trunk Broadcast Control.

Check the Enabled box for any interface, set the threshold, and click

CLI – Specify any interface, and then enter the threshold. The following

disables broadcast storm control for port 1, and then sets broadcast

suppression at 600 packets per second for port 2.

Console(config)#interface ethernet 1/1

Console(config-if)#no switchport broadcast

Console(config-if)#exit

Console(config)#interface ethernet 1/2

Console(config-if)#switchport broadcast packet-rate 600

Console(config-if)#end

Console#show interfaces switchport ethernet 1/2

Information of Eth 1/2

Broadcast threshold:

Multicast Threshold:

UnknownUnicast Threshold:

LACP status:

Ingress Rate Limit:

Egress Rate Limit:

Ingress Rate Limit Trap:

VLAN membership mode:

Ingress rule:

Acceptable frame type:

Native VLAN:

Priority for untagged traffic: 0

GVRP status:

Allowed VLAN:

Forbidden VLAN:

Figure 9-9 Port Broadcast Control

Enabled, 600 packets/second

Enabled, 500 packets/second

Disabled, 102400K bits per second

Disabled, Up:0 packets,Down:0