Led Light Replacement - VideoRay Defender MSS Operator's Manual

4. Carefully thread the disconnected cable and connector back through the frame until it is clear.
5. Using a Phillips head screw driver, loosen the 4 screws (2 in each bracket) that hold the Camera
to the frame.
6. Slide the camera out of the brackets from the front of the vehicle.
7. Slide the replacement Camera cable and then the replacement camera into the brackets and
make sure it is level with the tilt gear on the right (when viewed from the front of the camera)
and secure it using the Phillips head screws loosened earlier. Tighten the screws evenly and do
not over-tighten the screws.
8. Thread the cable and connector through the same routing as the old Camera. Connect the
cable to the same location on the Communications Module as before.
9. Replace the float block using the screws removed earlier.
Camera and Control Software Configuration
This section is reserved for future use.

LED Light Replacement

Replacing an LED Light requires both hardware replacement and software configuration procedures.
Each LED Light must be configured for its specific location on the vehicle. Configuration parameters
are identified in the LED Light
Hardware Replacement
To remove and replace an LED Light, follow these steps:
1. Power down the system.
2. Remove the top float block by removing the four screws holding the float block to the frame.
3. Note the position of the LED Light being replaced in the vehicle frame. The position of the LED
light being replaced will determine the configuration parameters to be programmed into the
replacement.
4. For the LED Light to be replaced, follow the LED Light cable to the main thruster / Light
connector stack (located under the main float block) and disconnect the damaged LED Light
from the stack.
5. Carefully thread the disconnected cable and connector back through the frame until it is clear.
6. Using a Phillips head screw driver, remove the 4 screws that hold the LED module to the tilting /
pivoting bracket.
7. Remove the damaged LED Light from the vehicle.
8. Note the serial number for the replacement LED Light. This number will be used to identify and
program the replacement LED Light once installed in the vehicle.
9. Mount the LED Light in the tilting / pivoting bracket and secure it using the Phillips head screws
removed earlier.
10. Thread the cable and connector through the same routing as the old LED Light. Connect the
cable to the same location in the connector stack as before.
11. Replace the float block using the screws removed earlier.
LED Light and Control Software Configuration
section of the Equipment Guide.