Connection Diagram; Closing The Device; Taking Into Operation; Maintenance/Servicing - Eaton Crouse-Hinds Series Operating Instructions Manual

Fig. 9
Item 3 Item 4
Item 1
Contact arrangement with switch
2-pole + PE 3-pole + PE
3-pole + N + PE
Standard Optional
Code for voltage and No. of poles
acc. to IEC
Voltage Colour
2-pole + PE
110 - 130V 50/60Hz yellow
200 - 250V 50/60Hz blue
3-pole + PE
200 - 250V 50/60Hz blue
480 - 500V 50/60Hz black
380 - 415V 50/60Hz red
600 - 690V 50/60Hz black
3-pole + N + PE
480 - 500V 50/60Hz black
380 - 415V 50/60Hz red
600 - 690V 50/60Hz black
10
Plug and socket system for industrial use 63 A,
3-pole, 4-pole and 5-pole, GHG 524
In order to ensure the required minimum
protection category, the cable glands are
to be tightened down.
Overtightening might impair the protection
category.
Attention: Metal flanges, metal plates and
metal cable glands shall be included in the
equipotential earth connection.
6.3.2 Plug and coupler
Item 2
Fig. 9: In general, only the sealing inserts fitted
in the plug and coupler may be used. When
mounting the cable, attention has to be paid
that sealing inserts matching the cable diameter
be used. After having connected the cable, the
coupling ring item 2 is to be screwed fingertight
until the sealing effect is obtained. Then the
screws item 4 of the pull-relief, item 3, are to
be tightened down.
Mind! Overtightening might impair the
pull-relief effect!
6.4

Closing the device

In order to ensure the required minimum
protection category, the cover screws, the
screws of the plug and of the coupler shall
be tightened down.
Overtightening might impair the protection
category.
Any foreign matter shall be removed from
the device.
6.5

Taking into operation

Prior to taking the apparatus into operation,
the tests specified in the relevant national
regulations shall be carried out.
Apart from that, the correct functioning and
installation of the apparatus in accordance with
these operating instructions and other
applicable regulations
will have to be checked.
Check the plug for any damages before putting
it in the socket.
The user must ensure that a uniform equipoten-
tial earth applies throughout when the plug and
socket system is operated.
The inappropriate installation and operation
of the plugs and sockets can entail the loss
h (PE)
of warranty.
4 h
6 h
9 h
7 h
6 h
5 h
7 h
6 h
5 h
7 Maintenance / Servicing
Before opening the enclosure, make sure
that the device is disconnected from the
voltage, or take appropriate protective
measures.
The required maintenance intervals depend
on the specific application and will therefore
have to be determined by the user dependent
on the conditions of use.
If during servicing, repairs prove to be
necessary, section 8 of these operating
instructions will have to be observed.
8 Repair / Overhaul /
Modifications
Repairs and overhaul may only be carried out
with genuine CEAG spare parts.
Modifications to the device or changes of
its design are not permitted.
9 Disposal / Recycling
When the apparatus is disposed of, the
respective national regulations on waste
disposal will have to be observed.
In order to facilitate the recycling of individual
components, plastic parts are provided with
the identification mark of the plastic material
used.
In case of disposal you can obtain additional
information from your Cooper Crouse-Hinds
branch.
Subject to modifications or supplement of the
product range.
GB