Basic Applications - Leica DISTO X310 How To Use Manual

Adjusting/Standardising/Calibration of tilt sensor (Tilt Calibration)
Follow these quick 9 steps to adjust or calibrate your device in case of an unlikely
discrepancy.

Basic Applications

Straight line single distance measurement
Basic usage is quite simple.
* For measurements, where there is nothing obvious at the other end for the laser to reflect back, it is
recommended that you use Leica branded Target plate.
Permanent / Minimum-Maximum measurement
This function enables determining the minimum or maximum distance from a specific
measuring point, e.g. the determination of room diagonals (maximum value) or horizontal
distance (minimum value).
 Beam and aim the laser on the selected target with the
 Pressing the
 To activate permanent measuring, aim the laser at your desired
location and press the
continuous laser and the display would show the min and max values
on the screen.
 Focus the laser on to the wall corner (for maximum measurement)
or to the horizontal side (for minimum measurement) at 0° with a
swaying movement as shown in the picture.
 To stop permanent/minimum-maximum measuring press
once.
1. Press &
The device display would show as Mers 1 Hor.
2. Place the device on absolute flat surface and press
3. Next the device display would show Mers 2 turn
180°.
4. Place the device on a horizontal surface with display
up and rotate it one round 18o° and press
5. Next the device display would show Mers 3 Ver.
6. Place the device upside down on a flat surface and
press .
7. The device display will show Mers 4 turn 180°.
8. Turn the device horizontally by 180° and place it again
on an absolutely flat surface and press
9. The device calibration is complete and screen displays
Ok Cal.
again records the measurement on device display.
key for 2 seconds. This will activate the
keys simultaneously for 2 seconds.
.
.
.
key.
key