Changing Units - Leica DISTO X310 How To Use Manual

Timer (Self trigger) or Auto release
Timer is used for self triggering the measuremnt once the laser is activated. The delayed
release through the timer is recommended for precise aiming e.g. at long distances. As it
avoids shaking of the device when pressing the measurement key.
 To set the timer, press the
and the countdown starts automatically if the laser is active. The timer has a
preset setting of 5 seconds and the delay can be adjusted to maximum of 60 seconds.
 You can increase and decrease the number of seconds by pressing
 Long pressing the timer key increases the rate of change of the values.
Memory
The device stores last 20 results by default.
 To view the results press the
& keys.
 To delete the memory records press
device is ready to record next 10 results.

Changing Units

Leica Disto X310 is provided with the stock of units that you can change as per your
requirement. You can change from meter to feet to inches as per your convenience.
Changing Tilt Units
You can also change the Tilt unit setting as well to measure your triangle angles in degrees
°or percentage %.
key once. The timer symbol appears on the display as
 By pressing the
through different units of measurements.
 They change in this order.
1. meter upto three decimal places
2. meter upto four decimal places
3. meter upto two decimal places
4. feet upto two decimal places
5. feet and inches
6. inches upto two decimal places
7. only inches
 Press
&
switch between and
navigate through last 10 readings with help of
& the together for 2 seconds and the
key each time for 2 seconds you can navigate
simultanaeously for 2 seconds and then
°
%
& units.
& .