Material Settings - GANN Hydromette BL Compact B 2 Operating Instructions Manual

Basic Functions
If the alarm function is turned on, a warning signal sounds when the
adjustable alarm value has been exceeded, and the measurement
value flashes. At the same time, the selected alarm value is shown
in the second line of the display.
2.2.2

Material Settings

Figure 2-2 Material selection
To change the preset for the material, the device must be switched
on and be in the main measurement mode (default after switching
on the device). After pressing the "Down" key the view as shown
in Figure 2-3 appears on the display. Press the "M" key (measure
key) briefly to change the preset for the material.
The material ID flashes and can be set using the "Up" and "Down"
keys. Press the "M" key again briefly to save the change.
The material table can be found in the Annex.
12
The specified
displayed with the icon for material
moisture.
Material icon and ID
Hydromette BL Compact B 2
material ID is