Warning Messages - Philips MML1941-PCR User Manual

WARNING MESSAGES

Check Input Signal
If the Video Signal is not available for the selected Video Source a warning message pops-up on the screen for about
5s.
When the monitor is properly calibrated (No warning messages in the information item) the displayed message is the
following:
XXX= Current Video Source (BNC, DVI, DSUB, DVI-A)
After about 15s the monitor enter the Stand-By mode.
The front LED turns orange.
To change the video source when the no video is available on the selected input, read the followings steps:
- Wait for the Warning Message.
- Execute the normal change of the Video Source using the OSD.
Input Available
After a video source change, if in the selected video source no video signal is available, the MML194x switches back
to the previous video source and shows the dialogue box here below:
Unsupported Mode
If the Video Timing is not available a warning message will appear on the screen for about 5s.
XXX= Current Video Source (BNC, DVI, DSUB, DVI-A)
After about 5s the monitor enters the Stand-By mode.
The front LED turns orange.
Warning: No interlaced video modes are supported.
42 MML194x