H3C SR6600 Command Reference Manual page 22

Field
deferred
collisions
late collisions
lost carrier
- no carrier
If an output field is not available, a hyphen (-) is displayed.
# Display the information about Layer 2 Ethernet subinterface GigabitEthernet 3/0/1.1.
<Sysname> display interface gigabitethernet 3/0/1.1
gigabitethernet 3/0/1.1 current state: DOWN
IP Sending Frames' Format: PKTFMT_ETHNT_2, Hardware Address: 000f-e245-7911
Description: gigabitethernet 3/0/1.1 Interface
Broadcast MAX-ratio: 100%
PVID: 1
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 1
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Table 1-4 display interface command (in Layer 2 subinterface mode) output description
Field
GigabitEthernet3/0/1.1 current state
IP Sending Frames' Format
Hardware Address
Broadcast MAX-ratio
PVID
Tagged VLAN ID
Untagged VLAN ID
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
Number of frames that the interface deferred to transmit because of
detected collisions.
Number of frames that the interface stopped transmitting because
Ethernet collisions were detected during transmission.
Number of frames that the interface deferred to transmit after
transmitting their first 512 bits, because of detected collisions.
Number of carrier losses during transmission. This counter applies to
serial WAN interfaces.
Number of times that the port failed to detect the carrier when
attempting to send frames. This counter applies to serial WAN
interfaces.
Current state of the Ethernet subinterface
Frame type of the Ethernet subinterface
Interface hardware address
Broadcast storm suppression ratio
Default VLAN ID
VLANs whose packets are sent through the port with VLAN tag kept.
VLANs whose packets are sent through the port with the VLAN tag
stripped off.
Statistics on the packets received
Statistics on the packets sent
1-10
Description
Description