SMC Networks EliteConnect SMCWHSG14-G User Manual page 49

Item
NTP Setting
Server IP/Domain Name
Time Zone
Update Time
Daylight Saving Time
NAT (Network Address Translation)
NAT
User Session Limited
IP Plug and Play (iPnP
Technology)
Layer 2 Isolation Security
Secure administrator IP
Addresses
Multicast Pass Through
Allow remote user to ping the
device
48
Default
Enables or disables NTP (Network Time Protocol)
Time Server. Network Time Protocol can be utilized to
Disable synchronize the time on devices across a network. A
NTP Time Server is utilized to obtain the correct time
from a time source and adjust the local time.
Enter the IP address/domain name of NTP server. The
Empty
maximum allowed characters length is 100.
GMT-12:00 Select the appropriate time zone for your location.
0 hours Enter the number of hours for update time.
Disable Enables or disables Daylight Saving Time (DST).
Set the Daylight Saving Time (DST) on the Wireless
Month/Day
Hotspot Gateway. Adjust the begin time and end time.
Enable Enables or disables NAT Address Translation function.
Enables or disables user session limit function. This
feature provides you an ability to control a number of
Enable,30
sessions allowed for particulars user(s) at the one
time.
Enables or disables plug & play function. When
Enable enabled, the user needn't change their network
configuration to access the Internet.
If enable plug and play is selected, you can enable
Layer 2 Isolation Security function. When the "Layer 2
Enable
Isolation Security"
communicate with each other.
Options: Any and Specify. Administrator can specify 5
Any IP addresses or a range to allow remote control access
from network.
This function allows for multiple transmissions to
Disable
specific recipients at same time.
This function allows remote user to ping the Wireless
Hotspot Gateway through Internet. Ping is normally
Enable
used to test the physical connection between two
devices, to ensure that everything is working correctly.
Description
enabled, everyone cannot
SMCWHSG14-G