Transmitter - GE 20543 User Manual

J
1. "Sync" switch:
See " REMOTE CONTROL
PAIRING INSTRUCTIONS"
in Page 14 for details.
Restore power to ceiling fan and test for
4.
proper operation.
7. " " button:
Test for proper operation.
This button controls the light on/off and
brightness settings. Press and release this
button to turn the light ON/OFF.
Press and hold the button to set the desired
brightness. The light will stop adjusting the
brightness when it reaches the maximum or
minimum light settings. Release this button
and press/hold again to adjust the brightness
again.
12
Operation Instructions
2. " O " and " I " dip switch:
For this fan, the switch should
be in the " I " position, allowing
for dimming of the light. Place
the switch in the "O" position to
turn the dimming feature off.
5. " , , and
These three buttons are used to
set the fan speed as follows:
= low speed
= medium speed
= high speed
8. " " button:
This button delays the light turning off
for approximately 5 seconds, enabling
you to exit your room before the light
turns completely off.
J
3. Install two 1.5-volt AAA batteries (K) provided
in the remote control bag.
Note :
.
To prevent damage to transmitter (J), remove the
batteries if not used for long periods.
.
Replace batteries as a simultaneous set – always replace
the whole set of batteries at one time, taking care not to
mix old and new ones, or batteries of different types.
.
Ensure the batteries are installed correctly with regard to
polarity (+ and -).
.
Please contact your local batteries recycling centre for
proper battery disposal information.
" buttons:
J
K
6. " " button:
This button turns the fan off.
Forward Reverse
9. The reverse switch is located on the top
of motor housing. Slide reverse switch to
change fan rotation. Slide the switch to
the left for warm weather operation. Slide
the switch to the right for cool weather
operation.
Note: wait for fan to stop before reversing
the direction of the blade rotation.