Spring Washer - GE 20543 User Manual

1.3 m 52 in. led lighted ceiling fan 120v 60hz

Available languages

SECURING FAN TO SECONDARY SUPPORT SYSTEM

Safety

cable

Drive a wood screw (A) and spring washer (D) and flat washer (E) into the side of the brace that holds the outlet box. Leave the 3 mm (1/8 inch) of space

between the support brace and washer. Insert the safety cable through the mounting bracket and one of the holes in the outlet box into the ceiling.

Adjust the length of the safety cable to reach the screw and washers by pulling the extra cable through the cable clamp until the overall length is correct,

put the end of the cable back through the cable clamp, forming a loop at the end of the cable. Tighten the cable clamp securely. Now put the loop in the end

of the safety cable over the wood screw and under the washer. Tighten the wood screw (AA) securely. Make sure the screw, washers and safety cable are

installed using the order pictured above.

PREPARING THE ELECTRICAL CONNECTIONS

If you feel you do not have enough electrical wiring

knowledge or experience, have your fan installed by a

licensed electrician.

Follow the steps below to prepare the electrical connections.

After that, conform with the descriptions and diagrams on

next pages to connect the fan to your household wiring. Use

the wire nuts supplied with your fan. Secure the wire nuts

with electrical tape. Make sure there are no loose strands or

connections.