Options - Anti-Tip Tubes; Options - Lap Belt - Sunrise Medical Breezy BasiX2 Directions For Use Manual

Options – sideguard
CAUTION!
Neither the side guards nor the armrests are to be used for lifting or
carrying the wheelchair.
CAUTION!
Take care of your fingers when adjusting the arm pad height.
SIDE GUARD, FLIP-UP, REMOVABLE WITH SHORT OR
LONG ARMRESTS, HEIGHT-ADJUSTABLE
The armrest can be height-adjusted
as follows.
Push the lever downwards and move
the armrest to the desired height.
Release the lever and press the
armrest downwards until you hear it
click into place. Always check that the
side guards are correctly in
place.
To flip the armrest up, push the lever
(1) so that the side guard is released.
You can adjust the length of the
armrest by releasing the screws (2) push the armrest to the desired
position and then re-tighten the screws (Fig. 28).
CAUTION!
Neither the side guards nor the armrests are to be used for lifting or
carrying the wheelchair.
CAUTION!
When using a 24" rear wheel the armpad must be moved one level
up.
SINGLE POST HEIGHT-ADJUSTABLE ARMRESTS
To adjust the height, pull the lever (1)
and move the armrest to the desired
height. Afterwards make sure that the
lever (1) locks back into position.
Removing the armrest is carried out
in the same way.
To remove the side guard completely,
push the lever (2). When fitting the
side guard, the lever (2) must also be
pulled.
Always make sure that the side guard
locks into position correctly in the receiver. (Fig. 29).
ANTI-TIP TUBES
Options – Anti-Tip Tubes
Anti-tip tubes provide additional
safety for inexperienced users when
they are still learning how to operate
their wheelchair. They prevent a
wheelchair from tipping over
backwards. The anti tip tube should
be inserted into the frame tube until
the first of the two spring buttons
enters the first hole in the frame tube,
(Fig.30).
WARNING!
Incorrect setup of the anti-tips will increase the risk of a rearwards
tip. You must swing the anti-tips upwards when going up or down
large obstacles, (such as a kerb), to prevent them from touching the
ground, then rotate them back down to the normal position.
16 BasiX
2
Fig. 28
1
2
Fig. 29
1
2
Fig. 30
NOTE: Do not insert both buttons of the anti tip tube into the frame
tube as this could damage the anti Tipp and cause a loss of
effectiveness. By pushing on the Second exposed release button,
the safety wheels can be set upwards or removed. There must
always be a gap of between 3 cm and 5 cm between the tube and
the ground. You must swing the safety wheels upwards when going
up and down large obstacles (such as a kerb) to prevent them from
touching the ground. Then rotate the safety wheels back down to the
normal position (Fig. 30).
WARNING!
Incorrect set up of the anti tips will increase the risk of a rearwards
tip.
Options – Lap belt
WARNING!
Before using your wheelchair ensure the seat belt is worn and
correctly adjusted before use.
The lap belt is fitted to the wheelchair as shown in the illustrations.
The seat belt comprises 2 halves. They are fitted using the existing
seat stay retaining bolt fitted through the eyelet on the belt. The belt
is routed under the rear of the side panel. (Fig. 31)
Adjust the belt position so buckles are in the centre of the seat. (Fig.
32)
Fig. 31
Adjust lap belt to suit the user's needs as follows:
To increase the belt To reduce the belt
length
Type A
Type B
Feed free belt Feed free belt back
through slide adjust- through male buckle
ers and male buckle and slide adjusters.
to provide more belt
length.
Fig. 32
lenght
Type A Type A
Type B
Type B
Ensure belt is not
looped at male
buckle.