Remote Sensor Installation And Mounting; Automatic Time Setting - Bresser 7002530 Instruction Manual

4. Replace the cover and retighten it with the screw.
Battery replacement
1. Press the RESET button on the sensor after every battery change.
2. Press the SCAN button on the base station to re-establish pairing.

11 Remote sensor installation and mounting

Depending on the desired location, the remote sensor can be put on the table or mounted on the wall.
NOTICE! During the installation make sure that the device is minimum 1.5 meters off the
ground.
The location should be as free as possible from obstacles to ensure an accurate measurement. The
remote sensor should be installed / mounted horizontally and within 100 m of the base unit.
Installation on a vertical tube (maximal tube diameter: 26 mm)
1. Place the back of the mounting base of the remote sensor on the tube and press the mounting
clamp against the tube from the other side.
2. Slide 4 screws through the bore holes of the mounting clamp and through the bore holes of the
mounting base on the other site.
3. Put on the 4 nuts and tighten the screw connection by hand.

12 Automatic time setting

After the power supply was established, the clock will automatically search for the radio signal. The
clock will automatically search for the radio signal.
If the radio signal is received correctly, the date and time will be set automatically and the radio control
signal icon turns on.
If the clock fails to receive the time signal, go ahead with the following steps:
1. Press RCC knob on the base station until radio signal symbol flashes.
2. If the device is still not receiving the signal, the time must be set manually.
Read the detailed manual for more information about manual time and alarm setting (see download in-
formation on page 2).
26 / 32