Before Starting Operation; Setting Up Power Supply - Bresser 7002530 Instruction Manual

15 HI Alert
17 Rainfall unit (in/h, mm/h)
19 MAX/MIN indicator
21 Battery level indicator (sensor)
23 HI/LO Alert
and Alarm on
25 Indoor humidity
27 Indoor temperature
29 HI/LO Alert for humidity and Alarm on

9 Before starting operation

NOTICE
Avoid connectivity disruptions!
To avoid connectivity disruptions between the devices, consider the following points before starting
operation.
1. Place base station (receiver) and remote sensor (sender) together as close as possible.
2. Set up power supply for the base station and wait until the indoor temperature is displayed.
3. Set up power supply for the remote sensor.
4. Position the base station and the remote sensor within the effective transmission range.
5. Ensure that the base station and remote sensor are assigned to the same channel.
When changing batteries always change batteries in the main unit as well as all remote units and re-
place them in the correct order, so the remote connection can be re-established. If either of the
devices is mains-powered, the power supply must be disconnected for a short moment also for this
device when exchanging the batteries. If batteries are exchanged in only one of the devices (i.e. the
remote sensor) the signal can't be received or can't be received correctly.
Note, that the effective range is vastly affected by building materials and position of the main and re-
mote units. Due to external influences (various RC devices and other sources of interference), the
maximum distance can be greatly reduced. In such cases we suggest to position the main unit and the
remote sensor at other places. Sometimes all it takes is a relocation of one of these components of a
few inches! Though the remote unit is weather proof, it should be placed away from direct sunlight,
rain or snow.

10 Setting up power supply

Basestation
1. Remove the battery compartment cover.
2. Insert the batteries into the battery compartment. Ensure that the battery polarity (+/-) is correct.
3. Replace the battery compartment cover.
4. Wait until the indoor temperature is displayed on the base station.
Remote sensor
1. Loosen the screws at the battery compartment cover with a small Philips screwdriver and remove
the cover.
NOTICE! Make sure not to lose the thin silicone sealing frame when removing the battery
compartment cover. It is an important protection against water infiltration and often ad-
heres at the battery compartment cover.
2. Insert the batteries into the battery compartment. Ensure that the battery polarity (+/-) is correct.
3. Put the sealing frame back onto the edge of the battery compartment.
16 HI Alert on
18 Outdoor indicator
20 Outdoor temperature
22 Outdoor sensor signal strength indicator
24 Indoor indicator
26 MAX/MIN indicator
28 Battery level indicator (base station)
30 HI/LO Alert for temperature and Alarm on
25 / 32