Programming Functions - Honeywell IAQPoint User Manual

Programming Functions

To access program functions, you must scroll through each of the
options in the menu until you reach the desired option.
This is a list of the possible menu options with brief descriptions. Refer
to the page number provided in the table for more detailed information
on each option.
Note that not all options are enabled on every unit. Available options
depend on the unit's factory programmed configuration.
Main Menu Options
Set Comm. IF
Set Address
Set BACNet MAC
Set BACNet ID
Set Baud Rate
Exec LON Serv.
CO2 Set Zero
CO2 Set Span
CO2 Setpoint
Temp Set Scale
Temp Set Offset
Temp Setpoint
RH Set Offset
RH Setpoint
LCD Mode
Reset Config
Quit
511838
11/07
Lets users select a specific communication
type, based on factory settings
Lets users enter a specific address for a unit
Lets users program a specific MAC address for
the device
Lets users assign a specific ID number to the
device
Lets users select a baud rate for their unit
Activates the service pin
Lets the user calibrate the unit's zero
Lets the user calibrate the unit's CO2sensor
Lets users specify the desired CO2 level
Lets users select either Celcius or Farenheit
Lets users specify a value by which to offset the
reading
Lets users specify the desired temperature level
Lets users specify a value by which to offset the
reading
Lets users specify the desired humidity level
Lets unit select a power saving mode
Resets unit to factory default settings
Lets users exit the programming menus
IAQPoint User Manual
Honeywell
Using the IAQPoint
Programming Menus
Sub Menu Options
21