Panasonic EYFLA4A Operating Instructions Manual page 13

WARNING
• Do not use other than the Panasonic bat-
tery packs that are designed for use with
this rechargeable tool.
• Panasonic is not responsible for any dam-
age or accident caused by the use of
recycled or counterfeit battery pack.
• Do not dispose of the battery pack in a
fire, or expose it to excessive heat.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack
in the same container as nails or similar
metal objects.
• Do not charge the battery pack in a
high-temperature location, such as next
to a fire or in direct sunlight. Otherwise,
the battery may overheat, catch fire, or
explode.
• After removing the battery pack from the
tool or the charger, always reattach the
pack cover. Otherwise, the battery con-
tacts could be shorted, leading to a risk
of fire.
• When the Battery Pack Has Deteriorated,
Replace It with a New One. Continued
use of a damaged battery pack may result
in heat generation, ignition or battery rup-
ture.
• To prevent leakage, overheating, smoke
generation, fire, and rupturing from occur-
ring, follow these instructions when han-
dling our rechargeable power tools (tool
main body/battery pack/charger).
- Do not allow material cuttings or dust to
fall onto the battery pack.
- When storing, remove any material cut-
tings and dust from the battery pack,
and place the battery pack separately
from metal objects (screws, nails, etc.)
when storing in the tool case.
• Do not handle the rechargeable power
tools in the following way.
(There is a hazard of smoke generation,
fire, and rupturing)
- Use or leave in places exposed to rain
or moisture
- Use submerging in water
Symbol
V
n
0
... min
-1
Ah
IV
. ASSEMBLY
CAUTION:
Make sure that the socket, extension or
any attachment used with the tool to hold
fasteners is designed specifically for power
tools (Impacting tools).
Using the tool with attachments designed
for hand tools may break the attachments
and cause possible danger.
Also, Make sure that there is nothing
wrong on the attachment before operating.
NOTE:
•
f a worn or deformed socket is used,
I
the square drive (retainer ring and pin)
may not enter the socket properly.
• When attaching or removing a bit,
disconnect battery pack from tool or
place the switch in the center position
(switch lock).
• Keep the temperature of the tool
above the freezing point (0°C/32°F)
when attaching sockets to or removing
them from the square drive on the
tool. Do not use excessive force when
attaching or removing sockets.
- 13 -
Meaning
Volts
Direct current
No load speed
Revolutions or reciprocations
per minutes
Electrical capacity of battery
pack
To reduce the risk of
injury, user must read and
understand instruction manual.
Do not incinerate or heat bat-
tery pack. Do not charge or
use under conditions of high
temperature. Do not expose to
high temperatures.
Do not disassemble or modify.
Do not expose to rain or water.
EN